Grease note summary
Flames from a fryer reach the filters in seconds. If grease has built up behind them, the fire is pulled into the duct, where it can travel out of sight to other parts of the building. Clean filters and a clean duct break that chain.
Most kitchen fires start small: a fryer left too long, oil overheated, a flare-up on a chargrill. What turns a small fire into a building fire is usually the extract.
Step one: the flame reaches the canopy
A fryer sits right under the hood, and the fan is pulling air upward all the time. When oil catches, the flame and hot gases go straight up into the filters. If the filters are clean, they slow things down. If they are clogged with grease, they become fuel.
Step two: the fire is pulled into the plenum and duct
Behind the filters is the plenum, then the duct. Grease that has slipped past dirty filters coats both. Bedfordshire Fire and Rescue explains how these deposits let fire travel from the cooking range into the extract system and spread through it. Because the fan keeps drawing air, the fire is fed and pulled along.
Step three: it spreads out of sight
Ducts run through ceiling voids, risers and other tenants’ space. A fire inside one can break out far from the kitchen, sometimes on another floor. BESA quotes London Fire Brigade figures of a kitchen extract ductwork fire in Greater London every nine days on average (BESA).
What breaks the chain
Clean filters. Washed daily or weekly depending on use, so less grease gets through. This is the kitchen team’s job, and the cheapest protection there is. Our filter rota note sets one out.
A clean duct. A specialist clean at the interval your cooking hours set, every 3, 6 or 12 months (BESA). Fryers count as heavy cooking, and London Fire Brigade guidance says heavy frying needs more frequent cleaning than the annual minimum.
Access to every section. A duct that cannot be reached cannot be cleaned. If a report lists sections as not reached, get panels fitted and those sections done.
Good fryer habits. Thermostats that work, oil changed on schedule, no fryer left running unattended, and a suppression system serviced where one is fitted.
Torch test: one filter, two minutes
Pull one filter and look behind it with a torch. If you can see a coat of grease on the plenum walls, the system is overdue. Book a full clean, canopy to outlet, through a kitchen extract cleaning company that can show readings afterwards. The duct cleaning page covers what that involves.
